Weston Pro Advantage Vacuum Sealer User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
SEAL MODE
Press the SEAL Button during the
vacuuming process or when using the Pulse
Button to initiate the seal (before the preset
vacuum pressure is reached). Also used for
only sealing vacuum bags without removing
the air from the bag.
To only seal vacuum bags without removing
the air from the bag:
1. Attach the Vacuum Sealer to the power
supply.
2. Press the ON/OFF Button (Figure 11) on the Control Panel to turn the Vacuum
Sealer “ON”. The ON/OFF Button on the display will illuminate and the Internal
Cooling Fan will run.
3. Press both of the Lid Release Buttons on each side of the Vacuum Sealer to
release the lid lock, then lift the Vacuum Lid to open.
4. Fill the vacuum bag with the product to be sealed. The open end of the vacuum bag
must be clean and dry to seal properly. HINT: When lling bags, fold over the top portion
of the bag, ll the bag, then unfold the top portion to seal.
5. Place the open end of the bag onto the Vacuum Chamber Seal and slightly into the
Vacuum Chamber. The Vacuum Post cannot be blocked or covered by the bag. Make
sure there are no wrinkles or creases in the bag in the sealing area.
6. Push down and close the Vacuum Lid and lock into place. The open end of the
bag should be sandwiched between the Seal Bar Insulator and the Seal Bar Heating
Element/Seal Bar Tape.
7. Press the SEAL Button (Figure 11), this will engage the Vacuum Pump and
Seal Bar Heating Element and seal the vacuum bag. The SEAL Button on the
display will illuminate while sealing. The appliance will stop automatically and “BEEP”
when the seal process is complete.
8. DO NOT try to open the Vacuum Lid before the vacuum has released or damage
may occur. Press both of the Lid Release Buttons on each side of the Vacuum Sealer
to release the lid lock, then lift the Vacuum Lid to open.
9. Remove the sealed bag. Wait at least 20 seconds before sealing another bag to avoid
overheating the unit.
10. Press the ON/OFF Button on the Control Panel to turn the Vacuum Sealer “OFF”.
11. Disconnect the Vacuum Sealer from the power supply.
Figure 11
Control Panel
NOTE: The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS. For
best results, only use the recommended vacuum bags with an embossed or mesh lining.
DO NOT USE HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other
than the uses described in this booklet, could potentially damage the appliance and void
the warranty!
9. Pour dépressuriser la boîte et ouvrir le couvercle, tourner le bouton/cadran à la
position d’ouverture.
10. Appuyer sur la touche ON/OFF du tableau de commande pour éteindre la scelleuse
sous vide.
11. Débrancher la scelleuse de la source d’alimentation.
Certaines pièces de la scelleuse sous vide
devront parfois être remplacées après un usage
fréquent. Une trousse d’entretien (vendue
séparément) (Figure 16) sera parfois nécessaire
au bon fonctionnement de la scelleuse sous
vide. REMARQUE : Enlever la mousse ovale
des garnitures en mousse du canal d’aspiration.
Jeter la mousse ovale, ne conserver que la
garniture en mousse externe (Figure 16a).
REMPLACEMENT DE LA
GARNITURE
DU CANAL D’ASPIRATION :
1. Appuyer sur la touche ON/
OFF du tableau de commande
pour éteindre la scelleuse sous
vide.
2. Débrancher la scelleuse de
la source d’alimentation.
3. S’assurer que la scelleuse a
entièrement refroidi.
4. Enfoncer les deux boutons
déclencheurs du couvercle de
chaque côté de la scelleuse pour
libérer le verrou, puis ouvrir le
couvercle.
5. Retirer la garniture
(REMARQUE : Le dos de la
garniture du canal d’aspiration
N’EST PAS adhésif.) (Figure
17) de la gorge entourant le
canal d’aspiration de la scelleuse
sous vide.
6. Loger une garniture neuve
dans la gorge entourant le canal
d’aspiration de la scelle
INSTRUCTIONS D’ENTRETIEN
Figure 16
Figure 17
Figure 16a
Abandonner
Garder
Garniture
du canal
d’aspiration
Trousse
d’entretien
AVERTISSEMENT! Avant de procéder à l’entretien, au montage ou
au démontage de la scelleuse, vérier qu’elle est ÉTEINTE et que sa FICHE EST
DÉBRANCHÉE DE LA PRISE/SOURCE D’ALIMENTATION !
Bande de
scellement
Garniture
du canal
d’aspiration
Canal
d’aspiration
-11--34-
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments